How to Make Easy handmade Jewelry for women - Making String Bracelet !!
Supplies essential for making the string bracelet:
- Golden Spacer Bead
- Crimp Bead
- Lobster Claw Clasp
- 0.5mm Tiger Tail Wire
- 1mm Nylon Thread
- Flat Nose Plier
Step1: Result in the spacer bead strand
1st, cut a 50cm long wire and connect a crimp bead at 5cm from your end;
2nd, slide the spacer bead one after one;
3rd, stop when the beads strand almost twice the length of your wrist circumference;
4th, attach another crimp bead at end to prevent beads from dropping and adjusting the tightness among beads on wire.
Step2: Wrap for the string
1st, cut a length of 1mm nylon thread, measuring about 100cm;
2nd, fold it by 50 %;
3rd, fold you beaded strand as picture shows and loop the thread across the area between initial two beads. Bring one end going over the beaded strand and yet another one going under;
4th, twist two ends together to turn the cord in other. Angling down to the subsequent gap and do it again above;
5th, continue crossing over and filling out the gaps;
6th, remove the two crimp beads at ends and tie both ends of tiger tail wire;
7th, secure two thread end using a tight knot. Make sure and then trim off any excess thread.
Step3: Attach the clasp
Open the jumprings and fasten the clasp at end!
So, there you’ve your string bracelet!